Chapter 3 practice: Ableton Live 12, exercises and listening
The Ableton Live 12 devices for this chapter, four exercises and a listening list.
3.8 In Ableton Live 12
| Idea from this chapter | Tool in Live 12 | Notes |
|---|---|---|
| Seeing the harmonic series | Spectrum | Drop it on any track; set Scale X to ST (semitones) to read partials as notes |
| Tuning kicks and percussion | Tuner | Reliable on long 808s and toms; for short kicks, read the lowest peak in Spectrum instead |
| Waveforms and harmonics | Drift, Analog, Wavetable | Compare sine, triangle, square and saw on the same chord |
| Inharmonic and FM sounds | Operator | Non-integer oscillator ratios give bell and metallic tones |
| Distortion | Saturator, Roar, Overdrive | Roar has multiple stages and routing for parallel and band-split distortion |
| Filters and resonance | Auto Filter, synth filters with key tracking | Use key tracking on wide-range parts |
| Detune and width | Unison in Wavetable; Chorus-Ensemble | Check the result in mono |
| Mono low end | Utility, Bass Mono | Keeps everything below the chosen frequency in mono |
| Tuned resonance | Resonators, Corpus, Spectral Resonator | Turn noise or drums into pitched, in-key textures |
3.9 Exercises
Exercise A: One chord, four sounds (40 minutes)
Write an Am9 voicing (A1 | G2 B2 C3 E3, with A1 at 110 Hz) and play it on four sounds: a sine, a triangle, a sawtooth and a distorted sawtooth. For each sound, adjust the voicing until it sounds as good as possible: remove notes, open the spacing, or move notes up an octave. Write down the final voicing for each. Expect the brighter sounds to end up with the simpler voicings.
Exercise B: Tune the low end (30 minutes)
Pick a key and find its root between E0 and B0 (41 to 62 Hz). Put Tuner or Spectrum after your kick and tune its body to the root or the 5th. Tuner works well on long 808s and toms but often can’t lock onto a short, punchy kick; in Spectrum, hover over the lowest tall peak to read its frequency. Then play the kick and a sine bass together on the root, and compare with the kick deliberately detuned by a semitone. The detuned version should sound weaker and muddier, even though nothing else has changed.
Exercise C: Distort intervals (20 minutes)
Through one heavy distortion, play in turn: a single note, an octave, a 5th, a major 3rd, a minor 7th and a full minor 9th chord. Listen to how the products of the distortion change. Then rebuild the minor 9th as two layers, a distorted root and 5th plus a clean upper voicing, and compare.
Exercise D: A melody with no new notes (20 minutes)
Hold a single saw note on A1 (110 Hz) with high filter resonance. Automate the cutoff in a 2-bar phrase so the resonance picks out the 3rd, 5th and 7th harmonics (the 5th, major 3rd and minor 7th above the root, a few octaves up) in a rhythm. You have just written a melody without changing the note.
3.10 Listening
For each track, listen for what the sound is doing to the harmony.
Phuture, “Acid Tracks” (1987). A single sequenced line where the filter cutoff and resonance carry most of the melodic movement.
Daft Punk, “Da Funk” (1995). A distorted, filtered synth riff: notice how the distortion fattens a simple line rather than a chord.
Boards of Canada, “Roygbiv” (1998). Detuned, wavering synth tones; listen for how the pitch drift colours simple harmony.
Brian Eno, “An Ending (Ascent)” (1983). Soft, slow-attack sounds that let sustained intervals overlap without becoming rough.
Jon Hopkins, “Open Eye Signal” (2013). A heavily processed bass whose timbre changes carry the track’s development.
Then take a track you know well and play its bass on a sine wave in a different octave. You may be surprised how much of the bass’s identity was its sound.